Jack's Magic Stain ID Kit - JMSTAINID

Ahorrar 54%
JACK'S MAGICSKU: JMSTAINID

Precio:
Precio de venta$12.99 Precio habitual$28.28
Stock:
Solo quedan 5 unidades

Retiro disponible en The Pool Supply Warehouse

Normalmente está listo en 24 horas

Envíos con cero emisiones de carbono con Shopify Planet
Envíos neutros en carbono en todos los pedidos
2,222kg
emisiones por envíos eliminadas
Equivalente a...
5,688
millas recorridas por un vehículo de gasolina promedio
Financiamos innovaciones en...
Captura directa de aire
Biopetróleo
Mineralización

Jack's Magic's Stain IDentification Kit gives pool owners an easy way to treat the staining problems in their pool by applying the proper treatment, simply by using this handy kit. Stain IDentification Kit gives you 4 easy-to-apply Jack's Magic test chemicals to use on the stain problem, and which quickly cuts through the stain is the product that will effectively remove them. This test kit will tell you what you need for treating your staining problems, saving you time and money.

Please Note:  The water should be at least 65-70 degrees in order to ensure accurate testing results. For information on how to perform the Stain Identification tests.

How important is it to have the chemistry within the parameters when doing the stain ID?
It’s very important! Most unsuccessful IDs or stain misidentifications are a result of not following the instructions.

My stain is in the deep end of the pool or on the wall; how do I do the ID?
There are a few different ways to address this issue. If you have adjusted your water balance according to the instructions and have the pump turned off, wait for the water to stop moving. Then you can sprinkle a small amount of each packet into the water. As the product dissolves it becomes a solution that is heavier than the water. This solution will sink to the bottom and begin to react with the stain. This process should be repeated with each product. Patience is the key to using this method as it takes time for the solution to sink and react.

Another method is to put a small amount of material in a piece of hosiery, attach it to the vac pole and hold it directly over the stained area. As before, this would need to be repeated with each product in the kit.

You may also like

Recently viewed