TropiClear® Stabilizer ensures effective, economical results from your chlorine sanitizer by slowing the breakdown of active chlorine due to the effects of sun, heat and other adverse effects. It will help maintain a continuous chlorine residual. This product is effective for stabilizing both liquid and dry types of chlorine sanitizers.
- Backwash or clean filter and measure cyanuric acid level.
- Chlorinate pool water to satisfy chlorine demand (2-4 ppm).
- Adjust pH of pool water to the 7.2-7.8 range. A pH of 7.4 is ideal
- for plaster pools and a pH of 7.6 is ideal for vinyl, fiberglass and
- painted pools.
- Through the skimmer, add TropiClear® Stabilizer at a rate of 2.5
- to 3 pounds per 10,000 gallons. [300 g-360 g per 10,000 L]. This
- should introduce about 30 to 35 g/L ppm of cyanuric acid.
- Alternatively, pre-dissolve required amount (as above in step 4)
- of TropiClear® Stabilizer in a bucket of hot water and stir.
- Remember this is a slow dissolving product. Add solution to pool
- by pouring along the perimeter.
- DO NOT backwash or clean filter for at least 48 hours.
- A cyanuric acid level of 40-60 ppm [40-60 g/L] is recommended. Use a test
- kit specific for cyanuric acid (Pool Stabilizer or Conditioner). Add
- TropiClear® Stabilizer until proper levels are attained and add
- as required throughout the year.
See dosage chart of label
WARNING: The following product(s) can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov